What should I pay attention to when installing stainless steel pipes?

The curvature of each part of the stainless steel pipe is constantly changing. Although the deformation caused by this curvature change is not large, its dirt and the linear expansion coefficient of the metal stainless steel tube are very different. The following is for everyone to pay attention to the installation of stainless steel pipe? I hope it can bring you good help.

The stainless steel pipe has uniform stress distribution and strong corrosion resistance. The process characteristic of stainless steel pipe is that during the forming process, the deformation is not caused by the forced flow of metal in the mold, but by the "soft forming" caused by the free flow process. Therefore, the forming process has strong resistance to stress corrosion due to no forced deformation, no stress concentration, small residual stress, uniform stress distribution and no defects.

When installing, the spacing of stainless steel pipe brackets shall not be greater than the spacing specified in the following table. The distance between the hot water pipe fixed supports should be determined according to the thermal expansion of the pipe and the allowable compensation of the expansion joint. The fixed bracket should be in close contact with the pipeline and fixed firmly.

In addition, the movable bracket should be flexible, and a gap of 3-5mm should be left between the sliding bracket and the sliding bracket. The bearing spacing of the thin-walled stainless steel pipe can be determined according to the data in the following table. The movable support of exposed pipe should use stainless steel pipe clamp. Plastic pipe clamps can also be used to install pipes with nominal diameters up to 25mm.